Chicago & The Surrounding Suburbs

Aluminum Sliding Glass Door Removal

Aluminum Sliding Glass Door Removal

Recently I discussed how to determine your existing moving glass door so you can purchase the vinyl replacement door. Today I am going to review the actions needed to eliminate the old sliding door prior to setting up the brand-new door.

The huge bulk of doors out there have the moving panel on the within half of the track, and the fixed panel is on the exterior. To get rid of the set panel, you require to eliminate the sill cap that snaps into the bottom track and runs from the set panel to the side jamb where the moving panel locks. You can raise the panel up as far as it will go into the leading channel and swing the bottom away from the track, and eliminate the panel.

Now, you desire to eliminate all the screws from the side jambs, leading header, and bottom track. Take a pry bar and get it under the bottom track about in the. Start with either half and raise the cut piece up towards the side jamb till the track piece separates from the side jamb.

Now you have to eliminate the side jambs. There will be numerous nails holding each jamb in location, so you desire to begin at the bottom and work your method to the leading corner. When you get the bottom 3rd loose, lots of times you can get the jamb with both hands and pull the rest of the nails complimentary as you go up.

At this moment you are prepared to set up the brand-new door. The setup treatment is a little various, depending upon whether you’re setting up a retrofit design frame or a replacement frame. We will talk about both treatments next week.

You have to get rid of the moving panel and the fixed panel. The huge bulk of doors out there have the moving panel on the within half of the track, and the fixed panel is on the exterior. To get rid of the set panel, you require to get rid of the sill cap that snaps into the bottom track and runs from the set panel to the side jamb where the moving panel locks. You can raise the panel up as far as it will go into the leading channel and swing the bottom away from the track, and eliminate the panel. As soon as the repaired panel is out, elimination of the moving panel is normally simpler.